Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
1.
Locate the programming button in the RKE harness near the RKE receiver.
2.
Open driver's door. Leave door open until programming is completed.
3.
Turn the ignition key to the "ON" position. Press and hold the programming button for about 15 seconds. The power door locks should lock and
unlock three times.
4.
While still holding the programming button down, press the "1" or "LOCK" button on the first transmitter. The door locks should lock and unlock.
5.
While still holding the programming button down, press the "1" or "LOCK" button on the second transmitter. The door locks should lock and
unlock.
6.
Release the programming button.
7.
Turn the ignition key to the "OFF" position.
8.
Verify that both transmitters operate properly.
Codealarm RKE With Security System
(1993 - 1996 models) (Port/Dealer installed - Not included in service manual)
System Operation:
Operates same as CodeAlarm RKE system, except also provides siren, alarm, and "panic" features. The status indicator light is also used as the alarm
override button. Can install on vehicles without power door locks to function as just an alarm system.
When the system is armed, unlocking a door with the key will activate the alarm. To disarm the system in this condition, press the "1" button or
simultaneously press the status indicator light and turn the ignition key and start the engine.
^
Arming: Press the "1" button to arm the alarm and lock all doors. The parking lights will blink and the siren will chirp. When the system completes
arming, the parking lights blink again and the siren chirps again. A status indicator light will begin blinking.
^
Activating: If the alarm is armed, it is activated by either opening a door or by the motion/pressure sensor. The siren sounds and the parking lights
flash. After a few minutes, the alarm deactivates and automatically re-arms itself. It the alarm has been activated, the status indicator light will blink
faster, indicating that the alarm was previously activated.
^
Disarming: Press the "2" button to disarm the alarm and unlock all doors. The parking lights blink, the siren chirps, and the dome light illuminates for
60 seconds or until the ignition key is turned to "ON." To disarm the system without a transmitter, simultaneously press the status indicator light
(which is also used as the alarm override button) and turn the ignition key to start the engine.
^
Panic Feature: Press both buttons "1" and "2" simultaneously to activate the alarm. Press either button to silence the alarm.
^
The dome light always illuminates for 1 minute after the ignition key is turned off.
Receiver Module Location: Behind knee bolster on driver's side
Ignition Switch Connection: WHITE, BLACK/WHITE and BLACK wires in 6-pin ignition switch connector on left side of steering column
Ground Connection: Behind left side kick panel, attached with a 10 mm hex bolt. Parking Light Connection: GREEN/WHITE wire in 7-pin combination
switch connector on upper left side of steering column
Door Lock/Courtesy Light Connection: At ETACS unit connected to fuse block
