Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
Technical Service Bulletins:
1992 models:
TSB-91-35-007 revises information for connecting and inspecting HU connector and the ABS valve relay harness and ABS ECU harness.
TSB-92-35-001 revises a troubleshooting "hint" when diagnosis code # 52 or # 53 is displayed.
TSB-92-35-005 corrects pin numbers for checking output voltages on the wheel sensors 1992-1993 models:
TSB-93-35-001 corrects four wiring harness connector numbers in the ABS circuit diagram on pages 231 and 234 of Vol. 2.
Notes:
1.
Codes are only detected while the scan tool is connected. Up to four codes can be displayed at a time. Code numbers are on Page 35-15.
2.
To erase codes with the MUT-I (not applicable to MUT-II), first connect the MUT-I directly to the battery for the test. Then display the Function
Menu. Select "# 4 SPECIAL TEST". From the SPECIAL TEST menu, scroll to and select # 5 ERASE DIAG". Answer "YES" to the question
"ERASE DIAG?". Choose "ID-NBR : 97" to erase codes four at a time. After erasing the DTCs, momentarily stop and restart the engine, and then
reactivate the MUT-I.
3.
When using scan tool in a road test, if a DTC is found, scan tool data will lock up and cannot be monitored further. Readings present at the time of
the DTC will remain on the screen. Correct the DTC cause and then retest.
4.
Diagnostics for Diamante Wagon are not included in the Diamante Wagon service manual. Refer to the 92-96 Diamante service manual for this
information.
5.
Diamante wheel speed sensors are fragile. To prevent damage, remove them when servicing the front end.
6.
If the hydraulic unit has to be replaced, refer to pages 6-3 and 6-4 in the ABS Student Learning Guide for important accumulator handling
precautions, some of which are included.
Eclispe 1991-94 /1995-96
System Type: for FWD: Nippon 2nd Generation 3 channel: for AWD: Nippon 2nd Generation 2 channel.
Diagnostic Page References:
1991 models: 1991 Eclipse Service Manual, Vol. 1, pages 35-9 thru 35-46. Circuit diagrams are in Vol. 2, Pages 119-121.
1992-94 models: for FWD: 1992-94 Eclipse Service Manual, Vol. 1, pages 35-9 thru 35-27; for AWD, pages 35-28 thru 35-46. Circuit diagrams are in
Vol. 2, pages 158-169.
Data Link Connector Location: Near driver side kick panel. See Service Manual Page 35-13.
(Refer to special scan tool instructions in this bulletin.)
Technical Service Bulletins:
1991 models:
TSB-90-35-002 clarifies the normal operating characteristics of the ABS.
1991-92 models:
TSB-91-35-007 revises information for connecting and inspecting HU connector and ECU connector, removal of fuse # 3, and the ABS valve relay
harness and ABS ECU harness. This information is correct in the 92-94 Eclipse Service Manual, Page 35-20.
