Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
12.
When the message "It transfers data to the memory card. Are you ready?" displays, press the check mark button.
13.
A progress monitor displays during data transfer to the memory card.
14.
When the message "Transfer is complete" appears, press the check mark button.
To remove the memory card:
15.
Double-click the removal icon in the lower right corner of the screen.
16.
Select "PCMCIA IDE/ATAPI Controller" . Then press the Stop button.
17.
Verify that the correct item is selected, then press the OK button.
When the message "The device can now be safely removed from the system" displays, remove the memory card (press the button next to the PC
card slot).
II. Reprogramming A Vehicle ECU With the Vci
After data is in the memory card, it can be downloaded to the VCI, then to the vehicles PCM (ECU). NOTE: Whenever the ECU is reprogrammed, a
reprogramming label (p/n MSSF-024G-00) must be completed and affixed to the vehicle. Refer to the applicable reprogramming TSB for specific
information that must be entered on the label.
VCI COMPONENTS
