Pickup 2WD L4-2350cc 2.4L SOHC 8 Valve (1996)
8.
FOR VEHICLES REGISTERED IN CALIFORNIA ONLY - Complete and provide to the vehicle owner a VEHICLE EMISSION RECALL -
PROOF OF CORRECTIONS FORM.
9.
Refer to section 13 of the service manual for ECM location and procedures. Replace the ECM with the new, updated ECM.
10.
After ECM replacement, engine idle may be unstable. To stabilize engine idle and ECM control conditions, start the engine and let it idle for 10
minutes under the conditions shown below:
^
Engine Coolant temperature: 85 - 95°C (185 - 203°F)
^
Lights and all accessories: OFF
^
Transmission/Transaxle: "N" or "P" position
^
Steering wheel: straight-forward position.
NOTE:
After ECM replacement, readiness codes must be re-established by completing the recommended OBD-II Drive Cycle TSB-00-13-005) before
returning to the I/M station for testing.
