mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Air Bag - Minimizing Deployment Risk|Page 914 > < Refrigerant Oil|Capacity Specifications|Page 907
Page 1
background image

Air Bag Module: Technical Service Bulletins
Air Bag - Minimizing Deployment Risk

NO.:  TSB-97-52B-001
DATE: February, 1997
MODEL: All SRS Models

SUBJECT:
AIR BAG DEPLOYMENT OUTSIDE THE VEHICLE

This bulletin supersedes TSB-91-52B-002, to include all SRS-equipped models and front passenger air bags.

BACKGROUND INFORMATION
Air bags are deployed by activating a small quantity of sodium azide, which is considered toxic when in its solid state. When ignited, sodium azide
releases a large volume of non-toxic nitrogen gas to inflate the air bag. Deployment is sudden because the nitrogen gas is produced very rapidly.
Precautions must be taken when deploying an air bag outside of the vehicle.

PURPOSE
Follow the precautions and procedures in this bulletin to minimize risk of personal injury when deploying an air bag module outside of the vehicle.

AFFECTED VEHICLES

All models equipped with Supplemental Restraint System (air bags):

PRECAUTIONS AND PROCEDURES

! WARNING

1.

To avoid personal injury, air bag deployment must be done on a wide, level ground without any persons or obstacles within a 20 foot radius.

2.

Do not deploy air bags in residential areas. A loud noise will be heard when the air bag module is deployed. If anyone is nearby, warn them of
the noise before deploying the air bag. Anyone near the deployment area should wear ear protection.

3.

Smoke is produced when the air bag is deployed. Select a well-ventilated area far away from a smoke detector. Though not poisonous, do not
inhale the smoke.

4.

Wear safety glasses and heavy gloves when handling an air bag module. If residue material does get into your eyes or on your skin,
immediately rinse the affected area with large quantities of clean water. If any irritation develops, seek medical attention immediately.

5.

Place the air bag module downwind of yourself and the deployment battery. Do not deploy the air bag module under windy conditions.

! WARNING

After disconnecting the battery cables, wait at least 60 seconds before proceeding. The SRS system is designed to retain enough voltage to deploy the
air bag for a short time after the battery has been disconnected. Unintentional deployment can cause serious injury.

DEPLOYMENT PROCEDURE

Air Bag - Minimizing Deployment Risk|Page 914 > < Refrigerant Oil|Capacity Specifications|Page 907