Pickup 4WD L4-155 2555cc 2.6L SOHC VIN E 2-bbl (1988)
Oil Pump: Service and Repair
Crankshaft, Bearings & Silent Shaft
Fig. 8 Rear oil seal removal
REAR OIL SEAL, REPLACE
1.
Remove screws attaching crankshaft rear oil seal retainer, then the retainer, Fig. 8.
2.
Remove separator from retainer, then the oil seal.
3.
Install new seal into retainer, then the separator. Ensure oil hole is positioned at separator bottom.
Fig. 9 Main bearing cap installation
MAIN BEARING CAPS
1.
Install main bearing caps in sequence and ensure arrows on caps are pointed in direction of timing chain, Fig. 9.
