Pickup 4WD V6-2972cc 3.0L SOHC (1991)
19. Align the drive gear with the mark made at the time of disassembly, and install the gear to the distributor shaft.
20. When aligning the drive gear's mating mark to the housing's mark, be sure that the notch "A" at the rotor end of the shaft is in the position shown in
Fig. 1. If no errors where made in either the marking or alignment procedures the pin holes should align properly. Drive in a new roll pin, insuring
that the slit in the pin is at a 90° to the distributor shaft.
Disc Installation Procedure
21. Install the spacer on the distributor shaft.
22. Insert the disc into the sensor part of the pick up unit assembly insuring the proper alignment with the notch on the spacer.
NOTE:Take care to install the disc with the correct side to the top as was observed during disassembly. Insure that the disc is clean and that the
disc's slits are clear of any foreign matter.
23. Install the rotor shaft and its retaining screw.
24. Install the cover so that the cover's indentation "A" is aligned with the housing's notch "B".
