Raider V6-3.7L SOHC (2006)
Garage Door Opener Transmitter: Testing and Inspection
Reprogramming Transmitter Codes
REPROGRAMMING TRANSMITTER CODES
CAUTION:
-
Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run the vehicle's exhaust while training the transceiver. Exhaust gas can cause
serious injury or death.
-
Your motorized door or gate will open and close while you are training the Universal Transceiver. Do not train the transceiver if people or pets are
in the path of the door or gate. A moving door or gate can cause serious injury or death to people and pets or damage to objects.
To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps:
1. Press and hold the desired HomeLink® button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink® button, proceed to step 3.
3. Position the end of your hand-held transmitter 1-3 inches (3-8 cm) away from the HomeLink® buttons while keeping the indicator light in view.
4. Simultaneously press and hold both the HomeLink button that you want to train and the hand-held transmitter buttons. Do not release the buttons
until step 4 has been completed.
NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the "Gate
Operator/Canadian Programming" section.
5. The HomeLink® indicator light will flash slowly and then rapidly after HomeLink® successfully receives the frequency signal from the hand-held
transmitter. Release both buttons after the indicator light changes from the slow to the rapid flash.
6. Press and hold the just trained HomeLink® button and observe the indicator light. If the indicator light stays on constantly, programming is
complete and your device should activate when the HomeLink® button is pressed and released.
NOTE: To program the remaining two HomeLink® buttons, begin with "Programming" step two. Do not repeat step one.
If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with "Programming" steps 6-8 to complete the
programming of a rolling code equipped device (most commonly a garage door opener).
7. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the
hanging antenna wire is attached to the motor-head unit.
8. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.)
NOTE: There are 30 seconds in which to initiate step eight.
9. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink® button. Repeat the "press/hold/ release"
sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a
third time to complete the programming.
HomeLink® should now activate your rolling code equipped device.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for
HomeLink® to pick up the signal during programming. Similar to this Canadian law, some U.. gate operators are designed to "time-out" in the same
manner.
If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live),
replace "Programming HomeLink®" step 3 with the following:
NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent possible
overheating.
3.Continue to press and hold the HomeLink® button while you press and release every two seconds ("cycle") your hand-held transmitter until the
frequency signal has successfully been accepted by HomeLink®. (The indicator light will flash slowly and then rapidly.) Proceed with "Programming"
step four to complete.
