Raider V6-3.7L SOHC (2006)
11. With the clip removed clean the surface around the hole and the underside of the clip with isopropyl alcohol or other non-residue cleaner.
NOTE:
Do not use an adhesive sealant. This clip must be removed during windshield replacement.
12. Apply a non-adhesive urethane sealant to the underside of the clip.
13. Reinstall the clip.
14. Inspect the cowl trim for a loose weatherstrip. If there are small detached sections use a permanent adhesive to re-secure it to the trim. If large
sections are detached replace the entire weatherstrip with a commercially available automotive quality self sticking foam weather stripping tape
(1/4" x 3/8").
15. Reinstall the cowl trim, retest for a water leak as described in steps 1-4, and confirm there is no water leak onto the passenger's floorboard.
16. Lower the vehicle and reinstall the wiper arm assemblies and blower motor. Check that the blower works on all speeds.
