Raider V6-3.7L SOHC (2006)
NOTE: The dust boot lip must be inserted before the piston
4. Slightly pull out lip portion of piston boot (3) so it protrudes past the bottom of the piston (2) and work lip into outermost groove on caliper
housing M.
5. Carefully press the lip (3) into the groove with a suitable tool (4) Avoid using sharp-edged tools. This will ensure that the lip is nested into the
groove all around before pushing the piston into the bore.
6. Press the piston fully into the bore using special tool C3716-A seal installer (3) with C-4171 Handle M.
7. Once the piston is pressed into the bottom of the bore, Check to see that the dust boot bellows are not inflated with air. If needed, push in between
the dust boot and piston to expel any trapped air.
INSTALLATION
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only Non-Petroleum based grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807 grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
