Raider V6-3.7L SOHC (2006)
5. Remove the brake line (1) from the brake hose (2) at the axle.
6. Remove the other end of the line (1) at the wheel cylinder (2).
7. Remove the line being replaced.
INSTALLATION
1. Install the line into the bend over tab at axle and then bend over the tab.
2. Install the brake line to the clip on the spring hanger.
NOTE: If brake line (3) was replaced
3. Install the brake line (3) at the brake hose (2) located at the axle.
4. Install the brake line (1) at the wheel cylinder (2).
