Raider V6-3.7L SOHC (2006)
Electronic Brake Control Module: Service and Repair
MODULE - ANTI-LOCK BRAKES
REMOVAL
NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. To program the ABM
refer to the Appropriate Diagnostic Information.
1. Remove the HCU from the vehicle
2. Remove the module mounting screws (1).
3. Disconnect the pump electrical connector (3) from the HCU (2).
4. Remove the module (1) from the HCU (2).
INSTALLATION
NOTE: If the ABM needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new ABM. To program the ABM
refer to the Appropriate Diagnostic Information.