Raider V6-3.7L SOHC (2006)
Wheel Speed Sensor: Description and Operation
SENSOR - WHEEL SPEED - FRONT
OPERATION
The Wheel Speed Sensor consists of a magnet 1 surrounded by windings from a single strand of wire (5). The sensor sends a small AC signal to the
ABM. This signal is generated by magnetic induction. The magnetic induction is created when a toothed sensor ring (exciter ring or tone wheel) 4
passes the stationary magnetic WSS. When the ring gear is rotated, the exciter ring 4 passes the tip of the WSS. As the exciter ring tooth approaches
the tip of the WSS, the magnetic lines of force expand, causing the magnetic field to cut across the sensors windings (5). This, in turn causes current to
flow through the WSS circuit in one direction. When the exciter ring tooth moves away from the sensor tip, the magnetic lines of force collapse cutting
the winding in the opposite direction. This causes the current to flow in the opposite direction. Every time a tooth of the exciter ring passes the tip of
the WSS, an AC signal is generated current. Each AC signal (positive to negative signal or squarewave) is interpreted by the ABM. It then compares
the frequency of the sinewave to a time value to calculate vehicle speed. The ABM continues to monitor the frequency to determine a deceleration rate
that would indicate a possible wheel-locking tendency.
The signal strength of any magnetic induction sensor is directly affected by:
^
Magnetic field strength; the stronger the magnetic field, the stronger the signal
^
Number of windings in the sensor; more windings provide a stronger signal
^
Exciter ring speed; the faster the exciter ring/tone wheel rotates, the stronger the signal will be
^
Distance 3 air gap between the exciter ring teeth and WSS; the closer the WSS is to the exciter ring/tone wheel, the stronger the signal will be.
The WSS is not adjustable. A clearance specification has been established for manufacturing tolerances. If the clearance is not within these
specifications, then either the WSS or other components may be damaged. The clearance between the WSS and the exciter ring is 0.005 - 0.050 in.
The assembly plant performs a Rolls Test on every vehicle that leaves the assembly plant. One of the test performed is a test of the WSS. To properly
test the sensor, the assembly plant connects test equipment to the Data Link Connector (DLC). This connector is located to the right of the steering
column and attached to the lower portion of the instrument panel. The rolls test terminal is spliced to the WSS circuit. The vehicle is then driven on a
set of rollers and the WSS output is monitored for proper operation.