Raider V6-3.7L SOHC (2006)
NOTE: The servo mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
9. Remove servo (2) from mounting bracket. While removing, note orientation of servo to bracket.
INSTALLATION
1. Position servo (2) to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip (3).
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install two servo-to-mounting bracket nuts (1) and tighten to 7 N.m (60 in. lbs.).
5. Position servo assembly (6) to inner fender and install three screws (3). Tighten 3 screws to 4 N.m (30 in. lbs.).
6. Connect vacuum line (1) to servo.
7. Connect electrical connector (5) to servo.
8. Connect servo cable (2) to throttle body.
9. Install air filter housing assembly.
10. Connect negative battery cable to battery.