mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Condenser HVAC|Description and Operation|Page 5562 > < Compressor Clutch Relay|Locations|Page 5558
Page 1
background image

Condenser HVAC: Description and Operation

CONDENSER - A/C

DESCRIPTION

The A/C condenser (1) is located in the front of the engine compartment behind the grille. The A/C condenser is a heat exchanger that allows the
high-pressure refrigerant gas being discharged by the A/C compressor to give up its heat to the air passing over the condenser fins, which causes the
refrigerant to cool and change to a liquid state.

The A/C condenser is equipped with tapping blocks for the A/C discharge line and the A/C liquid line (2) and mounting provisions for the power steering
cooler (3).

OPERATION

When air passes through the fins of the A/C condenser, the high-pressure refrigerant gas within the A/C condenser gives up its heat. The refrigerant then
condenses as it leaves the A/C condenser and becomes a high-pressure liquid. The volume of air flowing over the condenser fins is critical to the proper
cooling performance of the A/C system. Therefore, it is important that there are no objects placed in front of the radiator grille openings at the front of
the vehicle or foreign material on the condenser fins that might obstruct proper air flow. Also, any factory-installed air seals or shrouds must be properly
reinstalled following radiator or A/C condenser service.

The A/C condenser cannot be repaired and, if faulty or damaged, it must be replaced.

Condenser HVAC|Description and Operation|Page 5562 > < Compressor Clutch Relay|Locations|Page 5558