Raider V6-3.7L SOHC (2006)
HVAC housings.
-
If the A/C evaporator is being replaced, add 60 milliliters(2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant oil of
the type recommended for the A/C compressor in the vehicle.
5. Carefully install the A/C evaporator (1) into the lower half of the HVAC housing (2).
6. If removed, install the rubber flange (3) over the heater core tubes (4).
NOTE:
-
If the foam seal around the heater core is deformed or damaged, the seal must be replaced.
-
Make sure that the foam seal and the rubber flange are properly positioned in the HVAC housing.
7. Carefully install the heater core (1) into the lower half of the HVAC housing (2).
8. Align the air door pivot shafts with the pivot holes in the HVAC housing and install the two halves of the housing together (4).
9. Install the eleven screws (6) and the two metal clips (5) that secure the two housing halves together. Tighten the screws to 2 N.m (17 in.lbs.).
NOTE: If any of the foam seals are deformed or damaged, the seal(s) must be replaced.
