Raider V6-3.7L SOHC (2006)
4. Rotate the switch housing counterclockwise about 30 degrees to engage the tabs on the locking collar with the switch mounting bracket.
CAUTION: Do not release or pull up on the brake pedal before the switch plunger adjustment has been completed.
5. Release the brake pedal, but do not pull it upward.
6. Rotate the plunger adjustment release lever (2) clockwise until it locks into place. The lever should be parallel to the brake lamp switch connector
receptacle. This action will set the switch plunger length to a final adjustment position and cannot be undone. If not performed properly the first
time, a new brake lamp switch must be installed.
7. Reconnect the wire harness connector (5) to the brake lamp switch.
8. Reconnect the battery negative cable.
