Raider V6-3.7L SOHC (2006)
Brake Bleeding: Service and Repair
Base Brake System
MANUAL BLEEDING
Use Mitsubishi brake fluid, or an equivalent quality fluid meeting SAE J1703-F and DOT 3 standards only. Use fresh, clean fluid from a sealed
container at all times.
1. Remove reservoir filler caps and fill reservoir.
2. If calipers were overhauled, open all caliper bleed screws. Then close each bleed screw as fluid starts to drip from it. Top off master cylinder
reservoir once more before proceeding.
3. Attach one end of bleed hose (1) to bleed screw and insert opposite end in glass container (2) partially filled with brake fluid. Be sure end of bleed
hose is immersed in fluid.
NOTE: Bleed procedure should be in this order (1) Right rear (2) Left rear (3) Right front (4) Left front.
4. Open up bleeder, then have a helper press down the brake pedal. Once the pedal is down close the bleeder. Repeat bleeding until fluid stream is
clear and free of bubbles. Then move to the next wheel.
5. Before moving the vehicle verify the pedal is firm and not mushy.
6. Top off the brake fluid and install the reservoir cap.
PRESSURE BLEEDING
Use Mitsubishi brake fluid, or an equivalent quality fluid meeting SAE J1703-F and DOT 3 standards only. Use fresh, clean fluid from a sealed
container at all times. Follow the manufacturers instructions carefully when using pressure equipment. Do not exceed the tank manufacturers pressure
recommendations. Generally, a tank pressure of 15-20 psi is sufficient for bleeding.
Fill the bleeder tank with recommended fluid and purge air from the tank lines before bleeding. Do not pressure bleed without a proper master
cylinder adapter. The wrong adapter can lead to leakage, or drawing air back into the system.
