Raider V6-3.7L SOHC (2006)
NOTE: Engine and Transmission should be at normal operating temperature before performing this procedure.
1. Start engine and apply parking brake.
2. Connect scan tool and select transmission.
3. Select sensors.
4. Read the transmission temperature value.
5. Compare the fluid temperature value with the chart.
6. Adjust transmission fluid level shown on the dipstick according to the 42RLE Fluid Temperature Chart. Use only Mitsubishi ATF+4, Automatic
Transmission Fluid.
7. Check transmission for leaks.
Fluid/Filter Service
FLUID/FILTER SERVICE
NOTE: Only fluids of the type labeled ATF+4, Automatic Transmission Fluid, should be used in the transmission sump. A Filter change should be
made at the time of the transmission oil change. The magnet (on the inside of the oil pan) should also be cleaned with a clean, dry cloth.
NOTE: If the transmission is disassembled for any reason, the fluid and Filter should be changed.
1. Raise vehicle on a hoist. Place a drain container with a large opening, under transmission oil pan.
