Raider V6-3.7L SOHC (2006)
7. Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) from throttle body bellcrank.
8. Using a pick or small screwdriver (3), press release tab (2) to release plastic cable mount from bracket. Press on tab only enough to release cable
from bracket. If tab is pressed too much, it will be broken. Slide plastic mount (4) towards right side of vehicle to remove throttle cable from
throttle body bracket.
9. Remove throttle cable from vehicle.
INSTALLATION
1. Slide accelerator cable plastic mount into throttle body mounting bracket. Continue sliding until release tab (2) is aligned to hole in mounting
bracket.