Raider V6-3.7L SOHC (2006)
COMMON METRIC EQUIVALENTS
Refer to the Metric Conversion Chart to convert torque values listed in metric Newton- meters (Nm). Also, use the chart to convert between
millimeters (mm) and inches (in.).
Electrostatic Discharge (ESD) Sensitive Devices
All ESD sensitive components are solid state and a symbol is used to indicate this. When handling any component with this symbol, comply with the
following procedures to reduce the possibility of electrostatic charge build up on the body and inadvertent discharge into the component. If it is not
known whether the part is ESD sensitive, assume that it is.
1. Always touch a known good ground before handling the part. This should be repeated while handling the part and more frequently after sliding
across a seat, sitting down from a standing position, or walking a distance.
2. Avoid touching electrical terminals of the part, unless instructed to do so by a written procedure.
3. When using a voltmeter, be sure to connect the ground lead first.
4. Do not remove the part from it's protective packing until it is time to install the part.
5. Before removing the part from it's package, ground the package to a known good ground on the vehicle.
