Raider V6-3.7L SOHC (2006)
1. Install the output speed sensor (2) into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Loctite 242 Lock & Seal
Adhesive or equivalent.
2. Install the bolt to hold the output speed sensor into the transmission case. Tighten the bolt to 9 Nm (80 inch lbs.).
3. Install the wiring connector onto the output speed sensor
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
Sensor - Input Speed
SENSOR - INPUT SPEED
REMOVAL
