Raider V6-37L SOHC (2006) | Seat Belt Systems | Child Restraint | Tether Strap
1. Position the child tether strap (1) through the access hole in the cab back trim panel (2). Go to the upper cab back panel reinforcement (3).
2. Install and tighten the screw (5) that secures the child tether strap to the cab back. Tighten the screw to 14 Nm (10 ft. lbs.).
3. Fold the rear seat upper back pad (4) back against the cab back trim panel to conceal the tether strap.
TETHER ANCHOR - EXTENDED CAB - INSTALLATION
WARNING: TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT
ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT,
FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT
THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED
LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS
INTEGRAL THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT
COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE
CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE MITSUBISHI PARTS CATALOG.
NOTE: The following procedure applies only to the center upper child tether anchor used on all extended cab models.
1. Position the child tether anchor (1) through the access hole in the cab back trim panel (2). Go to the upper cab back panel reinforcement (3).
2. Install and tighten the screw (5) that secures the child tether anchor to the cab back. Tighten the screw to 14 Nm (10 ft. lbs.).
3. Fold the access door (4) back against the cab back trim panel to conceal the tether anchor.
Double Cab
CHILD RESTRAINT ANCHOR - REMOVAL
TETHER STRAP - DOUBLE CAB - REMOVAL
WARNING: TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT
ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER
STRAPS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT,
FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT
THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED
LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS
INTEGRAL THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT
COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE
CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE MITSUBISHI PARTS CATALOG.
NOTE: The following procedure applies only to the rear seat upper child tether straps used on double
