Raider V6-3.7L SOHC (2006)
3. Remove the screw 3.that secures the lower anchor to the outboard side of the front seat cushion frame (2).
4. Unsnap the upper edge of the trim cover (4) from the front seat belt turning loop and disengage the tab on the lower edge of the cover to access the
turning loop screw.
5. Remove the screw (5) that secures the seat belt turning loop to the height adjuster (2) on the upper B-pillar (1).
6. Remove the seat belt turning loop from the height adjuster.
7. Remove the upper trim (3) from the inside of the B-pillar.
8. Remove the lower trim (3) from the inside of the B-pillar 1.
9. Disconnect the body wire harness connector (6) from the seat belt tensioner initiator on the retractor (7).
10. Disengage the two clips that secure the belt web guide (2) to the B-pillar.
11. Remove the screw (4) that secures the upper retractor bracket to the B-pillar.
12. Remove the screw (5) that secures the lower retractor bracket to the B-pillar.
13. Disengage the tabs on the retractor bracket from the holes in the inner B-pillar.
14. Remove the front seat belt and retractor from the B-pillar as a unit.
FRONT OUTBOARD - DOUBLE CAB - INSTALLATION
WARNING:
