Raider V6-3.7L SOHC (2006)
1. From the front of the front seat, insert the front center seat belt (1) lower anchor through the opening in the trim (5) on the side of the center seat
cushion.
2. Engage the loose end and the tip of the front center seat belt through the elastic strap (2) on the side of the center seat cushion.
3. From behind the front seat, position the seat belt lower anchor to the center seat support bracket. Be certain to engage the anti.rotation tab on the
anchor into the corresponding hole in the center seat support bracket.
4. Install and tighten the screw (4) that secures the lower anchor to the center seat support bracket. Tighten the screw to 40 Nm (29 ft. lbs.).
5. Move the adjacent right front outboard seat (3) back to its rearward position.
Front Outboard
SEAT BELT & RETRACTOR - REMOVAL
FRONT OUTBOARD
WARNING:
-
TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL
RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, OCCUPANT
CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE.
THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.
-
TO AVOID PERSONAL INJURY OR DEATH, DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT ANCHOR
SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER STRAPS,
AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT, FRAYED,
OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT THAT
HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED
LATCH PLATE OR ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR
IS INTEGRAL THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT
COMPONENT. ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE
CORRECT, NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE MITSUBISHI PARTS CATALOG.
NOTE: The following procedure is for replacement of a faulty or damaged seat belt and retractor unit. The front retractor also includes a seat belt
tensioner. If the front seat belt or retractor is faulty or damaged, but the seat belt tensioner is not deployed, review the recommended procedures for
handling non.deployed supplemental restraints. If the seat belt tensioner has been deployed, review the recommended procedures for service after a
supplemental restraint deployment before removing the unit from the vehicle.
