Raider V6-3.7L SOHC (2006)
1. Engage the seat belt buckle (3) through the elastic strap on the inboard side of the outboard seat cushion.
2. Position the seat belt buckle lower anchor to the mounting hole near the rear of the inboard seat cushion frame. Be certain the notch at the base of
the anchor engages the anti.rotation tab on the frame.
3. Install and tighten the screw 1.that secures the anchor to the frame. Tighten the screw to 43 Nm(32 ft. lbs.).
4. On the driver side only, route the seat belt switch pigtail wire (2) under the inboard seat track and the seat cushion.
5. On the driver side only, move the front seat to its most forward position and tilt the seat back forward for easiest access to the seat belt switch
pigtail wire connection.
6. From behind the front seat on the driver side only, reconnect the seat belt switch pigtail wire connector (2) to the seat wire harness take out and
connector for the switch (3) located below the rear of the driver side seat cushion (1).
7. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
