Raider V6-3.7L SOHC (2006)
10. Close the lower ends of the trim cover halves together.
11. Using hand pressure, push the trim cover (1) down over the retractor (3) far enough to engage the two locator pins in the top of the inboard cover
half with the locator holes in the top of the retractor.
12. Reinstall the two plastic push.pin retainers (2) that secure the trim cover to the retractor.
13. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (3). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
14. Install and tighten the screw (4) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
15. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.