Raider V6-3.7L SOHC (2006)
7. Reinstall the lower trim (3) onto the inside of the B-pillar.
8. Reinstall the upper trim (3) onto the inside of the B-pillar (1).
9. Position the seat belt (6) turning loop onto the height adjuster (2) on the upper B-pillar.
10. Install and tighten the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Engage the tab on the lower edge of the trim cover (4) in the slot below the screw in the turning loop. Then press the upper edge of the trim cover
over the top of the turning loop until it snaps into place.
12. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (2). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
13. Install and tighten the screw (3) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
14. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.