Raider V6-3.7L SOHC (2006)
Camshaft Position Sensor: Service and Repair
SENSOR - CAMSHAFT POSITION
REMOVAL <3.7L>
The Camshaft Position Sensor (CMP) (3) is bolted to the front/top of the right cylinder head (1).
1. Disconnect electrical connector at CMP sensor.
2. Remove sensor mounting bolt (2).
3. Carefully twist sensor from cylinder head.
4. Check condition of sensor o-ring.
INSTALLATION <3.7L>
1. Clean out machined hole in cylinder head.
2. Apply a small amount of engine oil to sensor o-ring.
3. Install sensor (3) into cylinder head with a slight rocking and twisting action.