Raider V6-3.7L SOHC (2006)
That The Ignition Is In Run; Wait 30 Seconds After Changing The Seat Weight Before Proceeding To Allow The System To Stabilize; Only Press
Scan Tool Buttons When Directed To Do So; & Perform The Occupant Classification Module System Verification Test To Completion. See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests and Procedures/Airbag Systems/Occupant Classification System Verification Test
If crossmember or floorpan damage is present, repair or replace the components as necessary. Reinstall the seat in the vehicle. Turn the ignition
on. With the scan tool in OCM, select More Options, select System Tests, and select Occupant Classification Module System Verification Test.
Run the test by following the directions displayed on the scan tool. When the test is complete, Go To 1.
4. TEST SEAT FRAME
1. Turn the ignition off.
2. Remove the front passenger seat from the risers. Return the risers to their normal mounting position.
3. Turn the ignition on.
4. Using the scan tool, note the Passenger Seat Weight Sensor voltage for all four sensors. The voltage should be from 1.4 to 3.6 volts for each
sensor.
Q: Is any sensor's voltage reading out of the acceptable range?
YES: Go To 5
NO: Visually inspect for damaged or bent risers, a damaged or bent seat and seat structure, and damaged or bent seat tracks. Also, verify that the
holes in the center of the sensors line up with the seat track holes and that the seat track position locating tabs are locked in the same parallel slots.
If riser damage is apparent, replace the risers. Then, reinstall the Seat Weight Sensors, and Go To 6. If seat or seat track damage is present, replace
the components as necessary. Then, Go To 7
5. TEST SENSOR
1. Turn the ignition off.
2. Loosen the mounting screws of all of the Seat Weight Sensors, but do not remove them. Verify that the sensors are loose and that no binding
exists between the sensors and the risers.
3. Turn the ignition on.
4. Using the scan tool, note the Passenger Seat Weight Sensor voltage for all four sensors. The voltage should be from 1.4 to 3.6 volts for each
sensor.
Q: Is any sensor's voltage reading out of the acceptable range?
YES: Replace any Seat Weight Sensors that have an unacceptable voltage reading. Then, Go To 6.
NO: Replace the risers. Then, reinstall the Seat Weight Sensors, and Go To 6
6. CHECKING FOR IMPROPER SEAT WEIGHT SENSOR TORQUE
1. Turn the ignition off.
2. Tighten all of the Seat Weight Sensor mounting screws to specification.
3. Turn the ignition on.
4. Using the scan tool, note the Passenger Seat Weight Sensor voltage for all four sensors. The voltage should be from 1.4 to 3.6 volts for each
sensor.
Q: Is any sensor's voltage reading out of the acceptable range?
YES: Loosen the mounting screws of all Seat Weight Sensors with an unacceptable voltage reading, and repeat Steps 5 and 6.
NO: Go To 7
7. TEST SEAT TRACKS
1. Turn the ignition off.
2. Mount the front passenger seat on the risers.
3. Turn the ignition on.
4. Using the scan tool, note the Passenger Seat Weight Sensor voltage for all four sensors. The voltage should be from 1.4 to 3.6 volts for each
sensor.
Q: Is any sensor's voltage reading out of the acceptable range?
YES: Replace the seat track. Verify that no binding exists between the seat and risers. Then, repeat Steps 6 and 7.
NO:
