Raider V6-3.7L SOHC (2006)
6.
Using special tool MB992226, Serrated Socket, tighten the pulley to 54 Nm (40 ft/lbs).
7.
Install the plastic insulator cap on the pulley.
8.
Reinstall the alternator:
a.
Install the two horizontal bolts and one vertical bolt. Tighten the long horizontal and the vertical mounting bolts to 55 Nm (40 ft/lbs) and
tighten the short horizontal mounting bolt to 74Nm (55 ft/lbs).
b.
Install the field wire connector into the rear of the alternator.
c.
Install the B+ terminal eyelet to the alternator output stud. Tighten the mounting nut to 12 Nm (108 in/lbs).
9.
Reinstall the accessory drive belt.
10.
Reconnect the negative battery cable and reprogram the radio presets.
PARTS INFORMATION
WARRANTY INFORMATION
