Raider V6-3.7L SOHC (2006)
3. Make sure oil pan (1) and case rail are clean and dry. Install an 1/8 bead of RTV to the transmission oil pan and install to case. Tighten bolts (2) to
20 Nm (14.5 ft. lbs.).
4. Lower vehicle and connect the transmission range sensor (5) connector.
5. Connect solenoid/pressure switch assembly connector.
6. Connect the variable line pressure connector (4), if equipped.
7. Lower vehicle.
8. Fill transmission with ATF+4, Automatic Transmission Fluid. Verify proper fluid level.
NOTE: If the valve body has been reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.
