Raider V6-3.7L SOHC (2006)
3. Install companion flange onto the pinion with Installer C-3718 and holder.
4. Hold companion flange with Holder 6719A (2).
5. Install new pinion nut and tighten nut until there is zero bearing end-play.
CAUTION: Do not exceed minimum tightening torque when installing companion flange at this point. Failure to follow these instructions will
damage the collapsible spacer or bearings.
6. Tighten pinion nut to 27.1 Nm (200 ft. lbs.).
CAUTION: Never loosen pinion nut to decrease pinion bearing rotating torque and never exceed specified preload torque. If preload torque or
rotating torque is exceeded a new collapsible spacer must be installed.
7. Record pinion (1) rotating torque, with a torque wrench (2). Rotating torque should be equal to the reading recorded during removal plus an
additional 0.56 Nm (5 inch lbs.).
