Raider V6-3.7L SOHC (2006)
1. Place 1 TRS selector plate in the PARK position.
2. Position the transmission solenoid/TRS assembly onto the valve body. Be sure that both alignment dowels are fully seated in the valve body and
that the TRS switch contacts are properly positioned in the selector plate
3. Install the bolts (1) to hold the transmission solenoid/TRS assembly onto the valve body.
4. Tighten the solenoid assembly screws adjacent to the arrows cast into the bottom of the valve body first. Tighten the screws to 6 Nm (50 inch lbs.)
.
5. Tighten the remainder of the solenoid assembly screws to 6 Nm (50 inch lbs.).
6. Install the valve body into the transmission.
Sensor - Line Pressure
SENSOR - LINE PRESSURE
REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the line pressure sensor (2).
4. Remove the bolt holding the line pressure sensor (2) to the transmission case.
5. Remove the line pressure sensor (2) from the transmission case.
