Raider V6-3.7L SOHC (2006)
The wiper module cannot be adjusted or repaired. If any component of the module is faulty or damaged, the entire wiper module unit must be replaced.
OPERATION
The wiper module operation is controlled by the battery current inputs received by the wiper motor through the wiper on/off and wiper high/low relays.
The wiper motor speed is controlled by current flow to either the low speed or the high speed set of brushes. The park switch is a single pole, single
throw, momentary switch within the wiper motor that is mechanically actuated by the wiper motor transmission components. The park switch alternately
opens and closes the wiper park switch sense circuit to ground, depending upon the position of the wipers on the glass. This feature allows the motor to
complete its current wipe cycle after the wiper system has been turned Off, and to park the wiper blades in the lowest portion of the wipe pattern. The
automatic resetting circuit breaker protects the motor from overloads.
The wiper motor crank arm, the two wiper linkage members, and the two driven wiper pivots mechanically convert the rotary output of the wiper motor
to the back and forth wiping motion of the wiper arms and blades on the glass.
