Raider 2WD V6-3.7L (2008)
9. Position the retractor (1) mounting bracket to the mounting holes in the floor panel inboard of the door sill (4). Be certain that the seat belt
webbing between the retractor and the turning loop is not twisted.
10. Install the two screws (2) that secure the retractor bracket to the floor panel. Tighten the screws to 39 N.m (29 ft.lbs.).
11. Reconnect the body wire harness connector (3) to the seat belt tensioner initiator on the retractor.
12. Install the rear door sill scuff plates.