Raider 2WD V6-3.7L (2008)
2. Remove the center bezel lamp (4) from the instrument panel center bezel.
3. Depress the latch tab (2) and slide the hood (1) off of the end of the lamp housing.
4. Pull the base of the bulb (3) straight out of the bulb holder within the lamp housing.
LAMP INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the center bezel lamp (1) to the mounting hole in the center bezel above the forward storage bin of the center floor console.
2. Reconnect the wire harness connector to the lamp connector.
3. Engage the fixed retainer (2) of the lamp with one edge of the mounting hole in the center bezel.
4. Push the opposite end of the lamp upward until the retaining latch (4) snaps into the mounting hole.
5. Reconnect the battery negative cable.
BULB - INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the center bezel lamp bulb (3) with the bulb holder within the lamp housing (4).
