Raider 2WD V6-3.7L (2008)
5. Remove the upper shroud from the lower shroud and the steering column.
6. Remove the one center screw that secures the lower shroud to the steering column (4).
7. Remove the lower shroud from the steering column.
8. Disconnect the wire harness connector (2) from the Sentry Key REmote Entry Module (SKREEM) (1).
9. On vehicles equipped with the optional remote start system, disconnect the coaxial cable from the coaxial connector receptacle on the SKREEM.
10. Remove the screw (2) that secures the SKREEM (1) to the steering column housing.
11. Disengage the antenna ring (3) from around the ignition lock cylinder housing (4) and remove the SKREEM.
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the Sentry Key REmote Entry Module (SKREEM) (1) onto the steering column with the antenna ring (3) oriented around the ignition lock
cylinder housing (4).
2. Install and tighten the screw (2) that secures the SKREEM to the steering column housing. Tighten the screw to 2 N.m (20 in. lbs.).
