Raider 2WD V6-3.7L (2008)
5. Remove the inboard (4) and outboard (2) brake pads.
6. Remove the caliper adapter mounting bolts (5).
7. Remove the caliper slide pins from the adapter.
INSTALLATION
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only a Non-Petroleum based grease, such as
Dow Corning-807 grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807® grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
