Raider 2WD V6-3.7L (2008)
1. If removed, install the accumulator mounting bracket (4) and retaining nuts (3). Tighten the nuts to 6.8 N.m (60 in. lbs.).
2. Position the A/C accumulator (1) onto the mounting bracket. Do not tighten the accumulator bracket bolts (6) at this time.
3. Remove the tape or plugs from the opened refrigerant system connections.
4. Lubricate new rubber O-ring seals with clean refrigerant oil and install them onto the accumulator spring-lock coupler fitting. Use only the
specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/ C
compressor in the vehicle.
5. Connect the spring-lock coupler to the evaporator outlet tube (5) and install the secondary retaining clip (3).
6. Tighten the accumulator bracket bolts to 6.8 N.m (60 in. lbs.).
7. Connect the A/C suction line to the A/C accumulator.
8. Install the air filter housing.
9. Reconnect the negative battery cable.
10. Evacuate the refrigerant system.
11. If the A/C accumulator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. When replacing multiple
A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system. Use
only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
12. Charge the refrigerant system.
