Raider 2WD V6-3.7L (2008)
-
Splices are identified with an "S" and follow the same series numbering as the in-line connectors. In addition, S001-S099 numbers are located in
the engine compartment.
-
Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc.
identifier.
LOCATIONS
Connector/ground/splice location illustrations begin. The illustrations contain the connector name (or number)/ground number/splice number and
component identification. The connector/ground/splice location charts reference the figure numbers of the illustrations.
The abbreviation T/O is used in the component location section to indicate a point in which the wiring harness branches out to a component. The
abbreviation N/S means Not Shown in the illustrations.
Special Tool Note
6742
Pick Kit 6680
6932, 8538
