Raider 2WD V6-3.7L (2008)
1. Position the A/C discharge line (2) into the engine compartment.
2. Remove the tape or plugs from the opened discharge line fittings and the condenser and compressor ports
3. Lubricate new rubber O-ring seals with clean refrigerant oil and install them and new gaskets onto the discharge line fittings. Use only the
specified O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.
4. Install the A/C discharge line to the A/C compressor.
5. Install the nut (1) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 23 N.m (17 ft. lbs.).
6. Install the A/C discharge line to the A/C condenser (4).
7. Install the nut (3) that secures the A/C discharge line to the A/C condenser. Tighten the nut to 23 N.m (17 ft. lbs.).
8. Reconnect the negative battery cable.
9. Evacuate the refrigerant system.
10. Adjust the refrigerant oil level.
11. Charge the refrigerant system.
