Raider 2WD V6-3.7L (2008)
1. Position the air inlet housing (2) onto the top of the HVAC housing (6).
2. Install the four screws (4) that secure the air inlet housing to the top of the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
3. Connect the HVAC wire harness (5) to the blower motor resistor (3) and the recirculation door actuator (1).
NOTE: If the foam seal on the air inlet housing is deformed or damaged, the seal must be replaced.
4. Install the HVAC housing.
5. Reconnect the negative battery cable.
HVAC HOUSING
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the heater core, A/C evaporator, mode-air and blend-air
doors.
1. If removed, install the fresh air screen (3) onto the dash panel (4).
2. Position the HVAC housing (2) into the passenger compartment with the mounting studs and the condensate drain tube in their proper locations in
the dash panel.
