Raider 2WD V6-3.7L (2008)
7. Remove the lever and linkage rod (1) from the blend door pivot shaft (2) located on the top of the HVAC housing (3).
8. Carefully disconnect the lever and linkage rod from the blend door pivot lever (4).
9. Disconnect the HVAC wire harness (1) from the blower motor resistor (2), recirculation door actuator (3), and the blower motor (4).
10. Remove the three screws (5) that secure the blower motor to the HVAC housing (6) and remove the blower motor.
11. Remove the HVAC wiring harness from the HVAC housing.
