Raider 2WD V6-3.7L (2008)
Power Distribution Module: Customer Interest
Lighting - Trailer Lights Inoperative
N0: TSB-09-54-015
DATE: December, 2009
MODEL: 2008 Raider
SUBJECT:
TRAILER LIGHTS INOPERATIVE
This TSB supercedes TS8-08-54-070 issued July 2, 2008 to include ALL 2008 Raiders.
Revised information is italicized and indicated by -->.
PURPOSE
On some affected vehicles trailer tow lights may not function due to an improperly configured Front Control Module (FCM).
This Technical Service Bulletin advises dealers to reconfigure the FCM to enable the left and right trailer tow relay outputs. Dealers should apply these
instructions to affected vehicles in their inventory. Dealers should also address any sold vehicles when they return to the dealership for routine service or
repairs.
AFFECTED VEHICLE(S)
2008 Raider -->
REPAIR PROCEDURE
Preliminary Steps
1. Using the Superscreen review the warranty repair history to determine if this procedure has already been completed. If a warranty claim indicates that
the procedure has been previously completed do not continue with this Technical Service Bulletin.
Configure the FCM
Using the MUT-III change the status of the Trailer Tow Relay Outputs from Disabled to Enabled as follows:
1. Connect the MUT-III to the VCI using the USB 2.0 cable (MB991827). Connect the VCI to the data link connector of the vehicle using the MUT-III
main harness A with the blue connector (MB991910) and turn on the ignition.
2. From the Raider STV main menu click System Select.
