Raider 2WD V6-3.7L (2008)
3. Remove three PCM mounting bolts (2), and position ground strap (4). Remove PCM from vehicle.
INSTALLATION
CAUTION:
-
Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN) over the
bus network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you disconnect the ABS
CAB (controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM using a diagnostic scan
tool. This is done from the engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check VIN" from the
choices. Make sure it has the correct VIN entered before continuing. When the VIN is complete, turn off the ignition key and reconnect
the ABS module connector. This will prevent the setting of DTCs and other items associated with the lack of a VIN detected when you
turn the key ON after replacing the PCM.
-
Use a diagnostic scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original
mileage. If this step is not done, a Diagnostic Trouble Code (DTC) may be set.
1. Position PCM (3) to vehicle.
2. Install three PCM mounting bolts (2).
3. Tighten bolts to 3-5 N.m (30-40 in. lbs.).
