Raider 2WD V6-3.7L (2008)
The 2008 Raider is not equipped with a tow kit, but it is factory equipped with the trailer wiring harness connector.
Click the check mark at the bottom of the screen to continue.
8. Confirm that the status is set to Enabled. If so, no further action is necessary. Click the Home icon at the bottom of the screen to return to the Main
Menu.
If the status is set to Disabled, change it by clicking on the check mark.
Clicking the check mark will toggle the status between Enabled and Disabled.
9. After clicking the checkmark to change the status to enabled, this screen will appear advising:
"Trailer Tow Relay Outputs have been enabled. Cycle the ignition "Off' and then "On" and leave it in the "On" position for 10 seconds in order to
update the CCN with the new configuration."
After waiting 10 seconds, click the check mark at the bottom of the screen.
10. This screen will appear advising that the status is now enabled. The procedure is complete. Click the Home icon to return to the Main Menu.
PARTS INFORMATION
No parts are required.
WARRANTY INFORMATION
Dealers should apply this Technical Service Bulletin to affected vehicles in their new and used vehicle inventories. For affected vehicles, confirm that
this procedure has not previously been performed, repair as described and submit a normal warranty claim using the following information.
