Raider 2WD V6-3.7L (2008)
4. Carefully position the driver airbag (1) in the steering wheel (2). Be certain that the clockspring pigtail wires and the steering wheel wire harness in
the steering wheel hub area are not pinched between the driver airbag and the steering wheel armature.
5. From the underside of the steering wheel, install and tighten the two screws (3) that secure the driver airbag to the steering wheel armature.
Tighten the screws to 10 N.m (90 in. lbs.).
6. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component.
Air Bag - Passenger
AIR BAG - PASSENGER
REMOVAL
WARNING:
-
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result
in accidental airbag deployment.
-
To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should be worn.
There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation to the skin and
eyes.
NOTE: The following procedure is for replacement of an ineffective or damaged passenger airbag. If the airbag is ineffective or damaged, but not
deployed, review the recommended procedures for handling non-deployed supplemental restraints. If the passenger airbag has been deployed, review the
recommended procedures for service after a supplemental restraint deployment before removing the airbag from the vehicle.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the defroster grille from the top of the instrument panel.
3. Remove the glove box from the instrument panel.
4. Reach up into the instrument panel between the upper glove box opening reinforcement (2) and the cross car beam (1) to access and remove the
