Raider 2WD V6-3.7L (2008)
2. Position the side curtain airbag into the vehicle as a unit.
3. Align each of the two plastic push-in fasteners (7) on the airbag channel with their holes in the inner roof side rail and push them straight in until
they are fully seated.
4. Reconnect the body wire harness connector (2) for the side curtain airbag to the connector receptacle at the front of the inflator.
5. Loosely install the six screws (6) that secure the side curtain airbag to the U-nuts (3) in the inner roof rail (8).
6. Working from front to back, tighten each of the six screws. Tighten the screws to 6 N.m (50 in. lbs.).
7. Engage the metal clip (5) that secures the side curtain airbag rear tether to the cab roof rear header (4) above the rear window opening.
8. Engage the metal clip (10), then the two plastic retainers (9) that secure the side curtain airbag front tether to the inner A-pillar (1).
9. If the side curtain airbag was replaced due to a deployment, install the new headliner into the vehicle.
10. If the side curtain airbag was replaced for any reason other than a deployment, reinstall the headliner onto the inner roof panel.
11. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component.
