Raider 2WD V6-3.7L (2008)
9. Disconnect the body wire harness connector (6) from the seat belt tensioner initiator on the retractor (7).
10. Disengage the two clips that secure the belt web guide (2) to the B-pillar.
11. Remove the screw (4) that secures the upper retractor bracket to the B-pillar.
12. Remove the screw (5) that secures the lower retractor bracket to the B-pillar.
13. Disengage the tabs on the retractor bracket from the holes in the inner B-pillar.
14. Remove the front seat belt and retractor from the B-pillar as a unit.
REAR CENTER - DOUBLE CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor.
Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is
integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mitsubishi Parts Catalog.
NOTE: The right side of the rear center seat belt and retractor mounting bracket and the unique, keyed center seat belt lower anchor buckle/right
outboard occupant buckle unit are secured to the rear floor by a common screw, but the lower anchor buckle and the right outboard occupant buckle can
be removed from the mounting bracket and are serviced separately from the seat belt and retractor. The center anchor buckle and the right outboard
occupant buckle are serviced as a unit with their anchor brackets.
